Wrap Kit Product Installation Instruction by Rvinyl.com:

Rwraps Wrap Kit Installation Guideline Step 7: Film Application, the Second Pull - This application has multiple curves, we have pulled the film down over the fender previously and now we must pull the film over the headlight. Keep in mind all the curves you will be applying to and just how you will need to make the film conform to your surface prior to pulling the film in all directions. Rwraps Wrap Kit Installation Guideline Step 8: The Pressure Pull - To conform the film to this curved area, pull the film maintaining light pressure while squeeging towards your pressure hand. This action should move the air trapped under the film out towards your pressure hand. Rwraps Wrap Kit Installation Guideline Step 9: Conforming the Film - Note: we are using a blow torch with a low flam setting to heat the film.  This is a very advanced technique, use a hair dryer or a heat gun on a very low setting to heat the film. Heating the film will allow us to pull the film over the headlight and make it conform to extreme curves. Do not over heat the film or over pull it, you will either deform the film, burn  the film or otherwise damage it. This is only intended for certain films, If the film if foil based, you can not heat conform it.  Please contact us in regards to using this technique. Page: 1 2 3 4 5 6 7