The material seemed to be a little too small. I used a heat gun plus soap and water to do the install. I was finally able to get it to fit. When it was on it looked really good but didn't seem like it would last. After about a month, some parts started to peel back which i would stick back on with my hand. Then the side of the headlight where it bulges out started tearing. Finally, one day i noticed one side had fallen off while i was driving. I took the other side off and dumped it. The fog light material was way too small in diameter, it fit on the light but the outer edge of the lens is visible. I wish there was a hard plastic cover, but only this tint style is available. I would but another one but i don't think i want to waste money with the same outcome.