|
What
is Rvinyl Chrome Vinyl Film Wraps?
It is a mirror reflective adhesive backed bubble-free vinyl
film. It is sold by the sheet and can be applied to the exterior
or interior of just about any car, truck, SUV, motorcycle,
moped, ATV, etc. It has a removable protective layer to prevent
scratching during installation (remove after installation). The
film comes ready to apply, although application tools are not
included. The adhesive is semi-permanent (it can be removed, but
not reapplied). The film can be applied to flat hard surfaces
with gentle to extreme curves.
What size do I need?
We offer a variety of sizes, the size required depends on the
intended application area. We recommend you measure your
application area and purchase the most applicable quantity and
size. You may read in detail about how to measure your
application area for a proper kit installation in our
application instructions.
What size do I need?
Bubble-free film is manufactured using a special liner that
creates grooves on the adhesive side of the film. This
allows the bubbles or air pockets to "escape" by providing them
an air egress channel. During application, as bubbles may appear
simply squeegee the air pocket to the film's edge for a
bubble-free application.
How
do I install Rvinyl Chrome
Films?
The easiest way to answer this questions is for you to watch our
installation video at the top of this page. Installing Rvinyl Chrome film
can be significantly easier and less time consuming than using
spray paint, it can however still be a difficult process. Remember,
we sell vinyl film and not the ability to install it.
>
Installation difficulty depends on the ability of the installer.
> Depends on whether the surface has complex curves,
protrusions or is compounded.
> Depends on if the proper installation tools and fluids are
used.
> Depends on whether the installer is familiar with heat
stretching film.
What
Rvinyl application
tools do you recommend?
All of them. Installation can be difficult and the tools we sell
help guarantee results.
> The application squeegee will reduce air bubbles and aide in
heat conforming the tint.
> Low friction sleeves prevent "squeegee scratches."
> Rapid Prep removes any dirt or debris from your application
area.
> Rapid Tac will aide in the wet application of our Rvinyl
Chrome film.
> Rapid Clear will act as a finishing agent and polish on all
Rvinyl products.
> Seal-It Pens are used to seal the edges of all our vinyl
films.
> 3M Primer 94 is used to seal the edges of all our vinyl
films.
Do
you offer a warranty?
Rvinyl offers a limited warranty of 3 years. The film is
guaranteed to not fade, peel, crack, bubble or turn a different
shade when properly installed. This vinyl film is very
durable, UV stable and scratch resistant.
Do
Chrome Vinyl Film Wraps have a glossy finish?
Yes, this film has a glossy mirror finish and comes with a protective
liner that is removed after application.
Is the surface durable?
When applied correctly to the appropriate hard flat surface the Vinyl
film is very durable, UV stable and scratch resistant.
Will
Chrome Vinyl Film Wraps
fade in the sun?
No, it is coated with a UV protective layer which will last up
to three years outdoors.
Can it be cleaned?
Yes, once applied and bonded to your surface you may clean it
and polish it with such things Armor All or any type of cleaning
agent that is Acetate free. We recommend the use of Rapid Clear
for maintaining your Rwrap. |
 |