What is this product?
This Rvinyl Protection film is a "fusion product" that blends the worlds of protection and tint modification into a single film wrap kit. These urethane based protection kits bond to your tail lights with optically clear non-permanent adhesive. These kits are a much better alternative to bulky plastic covers or unreliable spray tints.

Designed to protect you vehicles tail lights, they can shield your expensive lights from 1" diameter stones hurled at your vehicle's lights at over 120mph! Durable enough to last up to 5 years of the harshest abuse, yet thin enough to appear as an OEM modification (17-20 mil thick).

How do I apply this product?
After applying the vinyl wrap film, you simply trim the excess vinyl with a sharp blade or hobby knife (not included). What you have left is a customized interior without the head aches and costs associated with painting the interior or trim pieces of your vehicle.

Are your lights safe with out it?
Years of outdoor exposure degrade OEM lights. Scratches and UV radiation turn tail lights yellow and milky-white over time, leading up to a 50% degradation in foot light candle output. Protection film prevents this.

What is the difference between Tint and Protection film?
Rvinyl Protection Kits are made from an optically clear 20mil (.020") thick clear film or a 17mil (.017") thick color film. Rvinyl Non-protective tint film uses a transparent vinyl which is 3mil (.003")thick. These films are not made from urethane, do not use optically clear adhesives, reduce light transmission and provide no light protection.

How do I know which wrap size film to purchase?
Measure the surface area where the film is going to be applied. Take into consideration any bends or compound curves that may need the material to bend when wrapping. Then choose the most applicable size for your need. A Tailor's Tape works well when measuring for bulk film.

Can the film be removed without damage?
Rvinyl protective film can be easily removed without damage to the light or original paint. Upon initial application, the film can be pulled back up and reapplied numerous times if not installed correctly. The film and adhesive are forgiving enough for this. Once the film has settled (approximately 48-72 hours) the product is not considered reusable. Upon removal warm the film and lift off slowly. If there is any additional adhesive left on the lens, simply rub the adhesive with isopropyl alcohol.

Are your colored films legal on tail lights for street use?
Our colored films may not be legal for street use on primary lighting. Please check your state or local laws before application. Our colored films do not produce a blue or red light when lit.  All non-clear films are intended for off-road show car use only.

Protection Film Properties
> Thickness of film plus adhesive: .017" - .020" (0.04318cm - 0.0508cm )
> Application temperature: 50F to 104F (10C - 40C)
> Rvinyl recommends an application temperature of 70-80F (21 -26)
> End Use temperature after application: -35F to 300F (-37.2C - 148.8C)
> Colored film grip level Softens at 185 - 215 degrees F
> Tensile strength is 3400-3800 psi (depending on mil thickness)
> Formulated with UV inhibitor
> Cold impact C level has no cracks at -35 degrees C
> Less than 1.5% shrinkage at 50 degrees C
> UV Radiation Protection at 58% (1 count = 023 MW min/cm2)
> Visible Glare Radiation Reduction at 39% (1 count = 1.3 MW min/cm2)
> Heat/Infrared Reduction is 5.1%