Okay, I knew from the beginning that this wasn't going to be an easy tint installation. With the Right angle on the housing as well as the big curve it makes installation really challenging. What i did was buy the kit but also a small roll of the same tint color. This turned out to be a life saver because unless you are the tail light tinting God i don't see how you could cover the entire housing with the S60 kit they sell. It didn't seem to cover everything and some of the cuts the made didn't work for me. I had to use some long pieces from the bulk roll to cover the upper part of the housing and trim them carefully with a razor blade. Then when i heated the film with a heat gun it looked really good. In my view this cannot be done without some clever two piece installation but im sure somebody out there could make it work. In the end it looks really nice it just took me about 3 hours to do both sides. (I took the tail light housing off and did it inside because i live in MN but it also made installation so much easier.)
